[. . . ] EXTRA CLIP STORAGE If you have an extra clip (sold separately), you can snap it into the detachable stock. T0 REPLACE BATTERIES ON LIGHT BEAM UNIT: Use a Phillips/cross head screwdriver (not included) to loosen screw in battery compartment door (screw remains attached to door). As with all small batteries, the batteries used with this toy should be kept away from small children who still put things in their mouths. [. . . ] Reset (switching off and back on again or removing and re-inserting batteries) if necessary. RECHARGEABLE BATTERIES: Do not mix these with any other types of batteries. As with all small items, these batteries should be kept away from children. If swallowed, seek medical attention immediately. N-STRIKE RECON CS-6 TM Barrel Extension Sight Flip-Up Sight Tactical Rail Cocking Mechanism Detachable Shoulder Stock 3. This should load another dart. Main Blaster Unit Trigger Light Beam Unit Power Switch Beam Selector Clip Clip Release Extra Dart Storage Clip Storage © 2008 Hasbro. Call: 1-800-327-8264 FOR NEW PRODUCTS AND OFFERS NERF. COM NOTE: Barrel Extension will also work with your N-STRIKE® LONGSHOT CS-6TM (sold separately). Light Beam Unit and Flip-Up Sight will work with any N-STRIKE blaster with Tactical Rail! N-STRIKE RECON CS-6 To Assemble: USING RECON CS-6 Ready Indicator 3. For enhanced targeting, slide Beam Selector to Red Dot position. USING THE PEEP SIGHT TACTICAL RAIL ACCESSORY! 1. Slide stock on to rear end of Main Blaster Unit until it clicks into place (To remove: Press release button down and pull stock off). Cocking Mechanism MUST be pulled all the way back for the Clip to load properly. [. . . ] For low light illumination, slide Beam Selector to Tactical Light position. Look along the notches in the disk, lining them up with the top of the front sight to center your target. [. . . ]